20112014 dodge charger ac blend door access provides all the information i need to access passenger side actuator.
Dodge charger blend door actuator location.
There is a fourth motor and door that controls the recirculation.
To remove the passenger side blend door actuator.
The actuator spins and moves a plastic gear which controls the blend door that plastic gear is a weak point and between my challenger and 2011 grand cherokee which use the same parts in vents i ve already replaced about 4 plastic gears and just 1 actuator.
These obstructions can include.
Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator feb 17 2015 2010 dodge nitro 1 answer.
The dual zone has one blend door actuator on the driver side and another blend door actuator on the passenger side.
The average cost for a dodge charger door lock actuator replacement is between 210 and 231.
In the 2011 dodge challenger there 2 located on the drivers side under the dash and close to the radio.
If you cannot move the blend door an obstruction has gotten in the way of the door movement which will make the new actuator fail.
There is also a different actuator motor and blend door to change the airflow from floor to defrost to vent etc.
Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing.
If the door is stuck the heater plenum with need to be removed and the problem resolved before installing the new unit.
Pen tooth pick small toy or bubble gum to name a few.
The dual zone climate control system uses two actuator motors to move the two blend doors one located on each side.
Disconnect and isolate the negative battery cable.