A slanted column on the other hand is equipped with a location curve.
Curved column line revit not seen on other floors.
Those floors will be ignored entirely.
Doubly curved surfaces generated by slab shape points are not supported.
This issue occurs because there is an incorrect view range in the main view.
Ami out of luck or is there some trick i don t know yet.
It follows the below procedure.
For vertical columns you can derive end points via level parameters and offsets.
When you tried to underlay a floor only doors and windows were visible.
To check click the worksets icon in the collaborate tab.
If you are using slabs with split lines and very steep angles you might want to model those floors as two floors using slap shape points.
First post here and i hope i am in the right place.
To see if this is the problem toggle on the reveal hidden elements tool.
In the main floor level the bottom of the primary range is set to main floor with an offset of 1.
If not apologies in advance.
See masking regions and filled regions.
Is your grids workset opened in the project.
If the element is part of a linked file do the following.
Konstru will store split lines and slab shape points but represent the floor outline only.
In plan view click view menu view properties.
I am trying to create a gap in a curved grid line but this seems beyond revit s capabilities.
To prevent the floor or slab from being visible in plan view you need to adjust the bottom clip so that it is more than 4 feet above the floor or slab and set the view depth so that it does not include any part of the floor or slab.
Ensure the link is visible in the view.
Verify that the element is not hidden by a masking region or a filled region.
Verify that your grids workset display yes in the opened column.
Structural analytical lines are not centered on columns when grade beams are off center.
Getting such information is not generally as easy as just getting a location curve.
See override individual lines in an element.
If the view range intersects the geometry of a level in your main view that level cannot be used as an underlay in the main view.
Thank you all kindly.
This is related to the auto detect settings for the column s analytical model and also the tolerances set in structural settings.
If your model in place intersects the cut plane at even just one point it ll show the entire model regardless of whether or not the other parts should be seen.
The application is working as expected and as designed however a setting change will address this.
See unload and reload linked models.
