With the g3 gold cup series there is no danger of element.
Curtis coffee maker water level error.
Your curtis g3 gold cup series is.
Coffee maker curtis cafe pc1 service manual 8 pages.
Check that the inlet valve is operating correctly.
Control will display when temperature reaches the setpoint 200 f.
If water is flowing in both the on and off positions the water inlet valve will need to be replaced by an authorized technician.
Water will fill the tank approximately 2 3 minutes depending on water flow rate.
When the water level in the tank rises to the correct volume the heating element will energize automatically.
My g3 brewer is indicating a water level error what should i check.
It takes approxi mately 20 minutes to reach setpoint temperature of 200 f.
Verify the flow rate to be a minimum of 1 gpm from outlet of the water filter.
The table below will help you fix the device.
Electrical issues the coffee maker could have problems with the water probe or universal control module.
If yes replace the water filter.
Reset the rear toggle switch the board should display filling heating ready to brew.
One minute while the other equipment is drawing water.
Curtis coffee maker troubleshooting coffee maker is a simple device but it can also break down due to wear and tear misuse rare scaling power surges and other reasons.
In other words you can disable the water volume level controls.
If not con sult a plumber.
Does the tank start filling.
Does the lcd read water level error.
Coffee maker curtis gem 612ild installation instructions service warranty information digital gemini high volume brewing systems 5 pages coffee maker curtis thermopro g4 service manual.
Either issue should be checked and repaired by.
Ensure that there is a flow rate of 1 gpm.
Remove the orange wire from the probe.
If you ve had no luck it is probably because the machine is set to not allow you to adjust the settings.
Basically the coffee machine can be set up so that no one can adjust the water level.
When the proper level is reached will appear on the screen.
Some type of water filtration device should be used to maintain a trouble free operation.
Broken water inlet valve turn the switch from on to off.
The heating tank will start to fill.
Unit is now ready to brew.
Connect a water line from the water filter to the brewer.
Setup steps all coffee brewers regardless of brand should be level left to right and front to back and located on a solid coun ter top.
